[Ampuh] How to fix problems with front rear disc brakes

[Ampuh] How To Fix Problems With Front Rear Disc Brakes

How to repair rear disc brake – Overhauling the brake features is a very important component for the vehicle.

With the role and function that is often used, namely to be able to slow down the speed of the vehicle, it is good when the vehicle passes through steep and steep roads or other road conditions.

In this case, the state of the brakes must, of course, be able to function correctly, as it is related to the safety of the driver of the vehicle.

Therefore, if we vehicle owners do not repair the brake damage, it will be fatal for the driver.

So that’s why we need to carry out regular maintenance because we are worried that when we drive the vehicle the brakes won’t work properly, so the problem that will be caused is that the brakes won’t lock because they are caused by brake linings that can be thin.

How To Fix Problematic Disc Brakes
How to Fix Problematic Disc Brakes “100% POWERFUL”

So as for the other factors that cause the brakes to not work properly, it could also be caused by the presence of an air bubble in the system.

So when that happens, the only thing we can do is just bleed.

However, when the brakes are applied, they become hard, making it difficult for them to grip, this could be because the master brake, i.e. the piston, is not working properly.

This is also usually caused because the brake piston in the master is dirty or damaged.

So what we have to do is just take it apart and then do a cleaning or it could be replacing it with a better/newer one.

Also Read: 25 Cheapest and Best Classic Motorcycles of 2019

How to fix disc brakes

So what steps can we take to deal with this case of disc brake damage? Here, Hargaindo.com will present a series of explanations and how to deal with it:

How To Fix Problems With Front And Rear Disc Brakes
How to Fix Problems With “100% POWERFUL” Front and Rear Disc Brakes
  • The first is to check the brake oil, if we find that the oil is running low, refill it immediately.
  • Then do a check on the disc brake pump that if there is a leak in the pump, immediately replace it with a new one, now several types of pumps that Hargaindo.com recommends for you, you can use a Nissin brand pump or Brembo, as if the pump You only repair what was damaged then the damage will happen again to your brakes as the pump performance is not optimal.
  • Next, check the hose on the pump that leads to the caliper, make sure there are no leaks that cause brake fluid to come out.
  • Then check the performance of your brake pads, pay attention if the conditions on the pads have diminished and immediately replace the brake pads with new ones, but if the condition of the brake pads is still coarse, just clean it using the air generated by the compressor.

If all these anticipation efforts were carried out by pal Mesinmotor.co.id, you will apply the next step, which is as follows:

How to blow wind on the disk

This step is the next step when we have done the above step. Well, here is a series of explanations:

How To Fix Problematic Disc Brakes
How to Fix Problematic Disc Brakes “100% POWERFUL”
  • The first is to release the caliper and disc from the disc.
  • Then put the hose and place it in the oil drain hole, this is done so that we can find out if there is air in the caliper.
  • Then pump in by pressing the brake lever up to 10 times and continue holding as the pressure enters the count of 10.
  • Then loosen some of the screws that are stuck around the drain where you installed the hose, then re-glue the screw, after that you can remove the brake lever.
  • You keep doing this until the air contained in the hose at the brake caliper section is completely out, now as a sign that the air has completely come out, then this will be seen along with the brake linings facing forward and both will go seem to coincide with each other. So when the brake oil runs out, you must fill it back up to the maximum limit.
  • If the position of the two brake pads is still close to each other, making the wheel speed stagnant, you can press it again using a screwdriver on the edge of the brake pad until you see that the two pads are open towards each other. another and adjust the disc width and then you can reinstall the caliper.
  • If all the above methods have been done, all of you have done it, then surely everything will work because some of the above methods are very powerful and practical.

So the series of discussions this time that Hargaindo.com can broadcast, with the hope that what we broadcast this time can be very useful and useful to all friends.

Read too:

Baca Juga :  NPC ex Prexy, found dead in condominium

You May Also Like